| *1 | REAR INPUT SHAFT RADIAL BALL BEARING | *2 | NO. 3 TRANSMISSION CLUTCH HUB |
| *3 | NO. 5 SYNCHRONIZER RING (for 5th Gear) | *4 | NO. 2 TRANSMISSION CLUTCH HUB |
| *5 | INPUT SHAFT | *6 | NO. 3 SYNCHRONIZER RING |
| ● | Non-reusable part | - | - |
1.INSPECT 6TH GEAR THRUST CLEARANCE
2.INSPECT 5TH GEAR THRUST CLEARANCE
3.INSPECT 4TH GEAR THRUST CLEARANCE
4.INSPECT 3RD GEAR THRUST CLEARANCE
5.INSPECT 6TH GEAR RADIAL CLEARANCE
6.INSPECT 5TH GEAR RADIAL CLEARANCE
7.INSPECT 4TH GEAR RADIAL CLEARANCE
8.INSPECT 3RD GEAR RADIAL CLEARANCE
33311Y
9.REMOVE REAR INPUT SHAFT BEARING SHAFT SNAP RING
Using a snap ring expander, remove the rear input shaft bearing shaft snap ring.
33337
10.REMOVE 6TH GEAR SUB-ASSEMBLY
|
|
Using SST and a press, remove the rear input shaft radial ball bearing and 6th gear sub-assembly from the input shaft as shown in the illustration.
33337A
11.REMOVE 6TH GEAR NEEDLE ROLLER BEARING
33396C
12.REMOVE NO. 5 SYNCHRONIZER RING (for 6th Gear)
3335A
13.REMOVE 6TH GEAR BEARING INNER RACE
3335AA
14.REMOVE 6TH GEAR BEARING INNER RACE LOCK BALL
Using a magnet hand, remove the 6th gear bearing inner race lock ball from the input shaft.
33395
15.REMOVE NO. 3 TRANSMISSION HUB SLEEVE
33394
16.REMOVE NO. 3 SYNCHROMESH SHIFTING KEY
33336
17.REMOVE 5TH GEAR
|
|
Using SST and a press, remove the No. 3 transmission clutch hub, No. 5 synchronizer ring (for 5th gear) and 5th gear from the input shaft as shown in the illustration.
33336A
18.REMOVE 5TH GEAR NEEDLE ROLLER BEARING
33359
19.REMOVE 5TH GEAR BEARING INNER RACE
33359A
20.REMOVE 5TH GEAR BEARING INNER RACE LOCK BALL
Using a magnet hand, remove the 5th gear bearing inner race lock ball from the input shaft.
33334
21.REMOVE 4TH GEAR
33334A
22.REMOVE 4TH GEAR NEEDLE ROLLER BEARING
33381
23.REMOVE OUTER 2ND SYNCHRONIZER RING
33334B
24.REMOVE 4TH GEAR BEARING SPACER
33364
25.REMOVE NO. 2 TRANSMISSION HUB SLEEVE
33366
26.REMOVE NO. 2 SYNCHROMESH SHIFTING KEY
33362A
27.REMOVE NO. 2 CLUTCH HUB SETTING SHAFT SNAP RING
Using a snap ring expander, remove the No. 2 clutch hub setting shaft snap ring.
33333
28.REMOVE 3RD GEAR
|
|
Using SST and a press, remove the No. 2 transmission clutch hub, No. 3 synchronizer ring and 3rd gear from the input shaft as shown in the illustration.
33333A
29.REMOVE 3RD GEAR NEEDLE ROLLER BEARING
33311A
30.REMOVE FRONT INPUT SHAFT BEARING
|
|
Using a press, remove the front input shaft bearing from the input shaft as shown in the illustration.