| *1 | FRONT DIFFERENTIAL CASE WITH RING GEAR ASSEMBLY | *2 | FRONT DIFFERENTIAL PINION THRUST WASHER |
| *3 | CENTER DIFFERENTIAL SIDE GEAR CONICAL SPRING WASHER | *4 | FRONT NO. 1 DIFFERENTIAL SIDE GEAR THRUST WASHER |
| *5 | FRONT DIFFERENTIAL PINION | - | - |
41300
1.INSPECT FRONT DIFFERENTIAL CASE WITH RING GEAR ASSEMBLY
2.INSPECT FRONT DIFFERENTIAL SIDE GEAR THRUST AMOUNT
41342A
3.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Secure the front differential case with ring gear assembly in a vise between aluminum plates.
Do not overtighten the vise.
Using a 5 mm pin punch and hammer, remove the front differential pinion shaft straight pin from the front differential case with ring gear assembly.
41342F
4.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
41341F
5.INSPECT FRONT DIFFERENTIAL PINION
41331F
6.REMOVE FRONT DIFFERENTIAL SIDE GEAR
| *1 | Front Differential Side Gear | *2 | Center Differential Side Gear Conical Spring Washer |
| *3 | Front No. 1 Differential Side Gear Thrust Washer | - | - |
| *a | Hold | - | - |
|
Turn | - | - |
Install SST as shown in the illustration and tighten it.
Do not overtighten SST, as doing so will damage the front differential side gears, center differential side gear conical spring washers, front No. 1 differential side gear thrust washers and front differential case with ring gear assembly.
Tighten SST until there is clearance between the front differential pinions and front differential side gears.
When removing the front differential pinions, do not overtighten SST, as it is necessary to rotate the front differential side gears.
Install SST as shown in the illustration, rotate the front differential side gear, and then remove the 2 front differential pinions and 2 front differential pinion thrust washers from the front differential case with ring gear assembly.
Do not drop the front differential pinion or front differential pinion thrust washer.
Remove SST from the front differential case with ring gear assembly, and then remove the 2 front differential side gears, 2 front No. 1 differential side gear thrust washers and 2 center differential side gear conical spring washers from the front differential case with ring gear assembly.
Do not drop the front differential side gear, front No. 1 differential side gear thrust washer or center differential side gear conical spring washer.