| *1 | FRONT DIFFERENTIAL CASE WITH RING GEAR ASSEMBLY | *2 | FRONT DIFFERENTIAL PINION THRUST WASHER |
| *3 | CENTER DIFFERENTIAL SIDE GEAR CONICAL SPRING WASHER | *4 | FRONT NO. 1 DIFFERENTIAL SIDE GEAR THRUST WASHER |
|
Gear Oil | - | - |
41331F
1.INSTALL FRONT DIFFERENTIAL SIDE GEAR
| *1 | Front Differential Side Gear | *2 | Center Differential Side Gear Conical Spring Washer |
| *3 | Front No. 1 Differential Side Gear Thrust Washer | - | - |
| *a | Hold | - | - |
|
Gear Oil |
|
Turn |
Coat the 2 front differential side gears, 2 front No. 1 differential side gear thrust washers and 2 center differential side gear conical spring washers with gear oil.
Install the 2 front differential side gears, 2 front No. 1 differential side gear thrust washers and 2 center differential side gear conical spring washers to the front differential case with ring gear assembly.
Do not drop the front differential side gear, front No. 1 differential side gear thrust washer or center differential side gear conical spring washer.
Make sure that the center differential side gear conical spring washer is installed with the correct orientation.
Install SST as shown in the illustration and tighten it.
Do not overtighten SST as doing so will damage the front differential side gears, center differential side gear conical spring washers, front No. 1 differential side gear thrust washers and front differential case with ring gear assembly.
Tighten SST to create the necessary clearance to install the front differential pinions.
When installing the front differential pinions, do not overtighten SST, as it is necessary to rotate the front differential side gears.
41341F
2.INSTALL FRONT DIFFERENTIAL PINION
|
Gear Oil |
|
Rotate |
Coat the front differential pinion and front differential pinion thrust washer with gear oil.
Using SST as shown in the illustration, rotate the front differential side gear and install the 2 front differential pinions and 2 front differential pinion thrust washers.
Be careful not to catch your fingers between the front differential pinion and front differential case with ring gear assembly.
Do not drop the front differential pinion or front differential pinion thrust washer.
3.INSPECT FRONT DIFFERENTIAL PINION BACKLASH
41342F
4.INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT
|
Gear Oil | - | - |
Coat the front No. 1 differential pinion shaft with gear oil.
Install the front No. 1 differential pinion shaft to the front differential case with ring gear assembly so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case with ring gear assembly.
41300
5.INSPECT FRONT DIFFERENTIAL CASE WITH RING GEAR ASSEMBLY
41342A
6.INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a 5 mm pin punch and hammer, install the front differential pinion shaft straight pin to the front differential case with ring gear assembly.
Using a chisel and hammer, stake the front differential case with ring gear assembly.