| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | CENTER NO. 4 ENGINE UNDER COVER | 51447D | - | - | - |
| 2 | CENTER NO. 1 FLOOR BRACE | 57543C | - | - | - |
| *A | for TMMF Made | *B | for TMC Made |
| *A | w/o Differential Pressure Sensor | *B | w/ Differential Pressure Sensor |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
51447D
1.REMOVE CENTER NO. 4 ENGINE UNDER COVER
57543C
2.REMOVE CENTER NO. 1 FLOOR BRACE (for TMMF Made)
17410
3.REMOVE FRONT EXHAUST PIPE ASSEMBLY
|
|
58151
4.REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR
|
|
89467B
5.REMOVE AIR FUEL RATIO SENSOR
6.REMOVE WIRE HARNESS CLAMP BRACKET
|
|
25760
7.REMOVE VACUUM TRANSMITTING HOSE ASSEMBLY (w/ Differential Pressure Sensor)
25733A
8.REMOVE NO. 1 VACUUM PIPE (w/ Differential Pressure Sensor)
|
|
17167
9.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
|
|
| *A | w/ Differential Pressure Sensor | *B | w/o Differential Pressure Sensor |
17118
10.REMOVE MANIFOLD STAY
|
|
17141
11.REMOVE EXHAUST MANIFOLD
|
|
| *A | w/ Differential Pressure Sensor | *B | w/o Differential Pressure Sensor |
17173
12.REMOVE EXHAUST MANIFOLD TO HEAD GASKET
17168
13.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR