| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY | - | - | - | - |
| 2 | STEERING SENSOR | 89245B | ( )
|
- | - |
| *1 | SPIRAL CABLE SUB-ASSEMBLY | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering angle sensor removal/installation are shown below.
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
89245B
2.REMOVE STEERING SENSOR
| *a | Guide | *b | Pin |
Disengage the 6 claws, 2 guides and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.