| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | DECK TRIM SIDE PANEL ASSEMBLY RH | 64730B | - | - | - |
| 2 | TIRE PRESSURE WARNING ECU AND RECEIVER | 897B0A | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
64730B
1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>REMOVAL
897B0A
2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
|
|