| *A | w/ Deck Board | *B | for Separate Type |
| *C | for Integrated Type | *D | w/ Cover |
| *A | for LH Side | *B | for 40/20/40 Split Seat Type |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 13 | BENCH TYPE REAR SEAT CUSHION ASSEMBLY | - | ( )
|
- | - |
| 14 | REAR SEAT CUSHION LOCK HOOK | 72693 | - | - | - |
| *A | for Gasoline Model | *B | for HV Model |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 15 | REAR FLOOR FINISH PLATE | 58387B | - | - | - |
| 16 | REAR UNDER SIDE COVER | 76973F | - | - | - |
| 17 | REAR DOOR INSIDE SCUFF PLATE | 67917F | - | - | - |
| 18 | REAR DOOR OPENING TRIM WEATHERSTRIP | 62331A | - | - | - |
| 19 | NO. 2 ROOM LAMP ASSEMBLY | 81250 | - | - | - |
| 20 | DECK TRIM SIDE COVER | 64714C | - | - | - |
| 21 | DECK TRIM SIDE PANEL ASSEMBLY | 64730B | - | - | - |
| *A | for Gasoline Model | *B | for HV Model |
| *C | LH Side | *D | w/ Hook |
| *E | w/o Hook | - | - |
| *1 | LUGGAGE HOLD BELT STRIKER ASSEMBLY | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 22 | REAR SEAT OUTER BELT ASSEMBLY | 73360D | - | - | - |
| 23 | ROOF SIDE INNER GARNISH | 62471A | - | - | - |
| 24 | REAR SEAT OUTER BELT ASSEMBLY | 73360D | - | - | |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear seat outer belt assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD.
The following procedure is for LHD.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
64910J
3.REMOVE TONNEAU COVER ASSEMBLY
58410B
4.REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)
64771G
5.REMOVE SPARE WHEEL COVER (w/ Cover)
71940A
6.REMOVE REAR SEAT HEADREST ASSEMBLY
71960B
7.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
73350C
8.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
71349E
9.REMOVE REAR SEAT BACK HINGE COVER (for 40/20/40 Split Seat Type)
71940A
11.REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
72693
14.REMOVE REAR SEAT CUSHION LOCK HOOK
58387B
15.REMOVE REAR FLOOR FINISH PLATE
76973F
16.REMOVE REAR UNDER SIDE COVER (for HV Model LH Side)
67917F
17.REMOVE REAR DOOR INSIDE SCUFF PLATE
62331A
18.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
64730B
21.REMOVE DECK TRIM SIDE PANEL ASSEMBLY
73360D
22.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY
62471A
23.REMOVE ROOF SIDE INNER GARNISH
73360D
24.REMOVE REAR SEAT OUTER BELT ASSEMBLY
Disconnect the pretensioner connector.
Remove the bolt to disconnect the shoulder anchor of the rear seat outer belt assembly.
Remove the 2 bolts.
Disengage the guides to remove the rear seat outer belt assembly.