Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH (for Gasoline Model LHD) › from 2021.07
RM3700E _54 Brake _093767 BRAKE SYSTEM (OTHER) _0480874 VACUUM WARNING SWITCH(for Gasoline Model LHD) G

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for Gasoline Model LHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55815E 4.REMOVE FRONT NO. 1 VENTILATOR SEAL

Hide 55701J 6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 83390H 7.INSPECT VACUUM WARNING SWITCH ASSEMBLY

a.

Start the engine and stop it after 1 or 2 minutes.


b.

Disconnect the connector from the vacuum warning switch assembly.


c.

Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher



d.

With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω



e.

Connect the connector to the vacuum warning switch assembly.


Hide 55701J 8.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 55815E 10.INSTALL FRONT NO. 1 VENTILATOR SEAL

Hide 11.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY