| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | HEADLIGHT ASSEMBLY | - | - | - | - |
| 2 | HEADLIGHT ECU SUB-ASSEMBLY | 81056 | ( )
|
- | - |
| 3 | HEADLIGHT GASKET | 81134 | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE HEADLIGHT ASSEMBLY
81056
2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY
|
|
81134
3.REMOVE HEADLIGHT GASKET
|
|