| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT BUMPER ASSEMBLY | - | - | - | - |
| 2 | HEADLIGHT ASSEMBLY | 81150 | ( )
|
- | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT BUMPER ASSEMBLY
81150
2.REMOVE HEADLIGHT ASSEMBLY
Apply protective tape around the headlight assembly as shown in the illustration.
| *A | w/o Adaptive High Beam System | *B | w/ Adaptive High Beam System |
| *C | for TMC Made | *D | for TMMF Made |
| *E | for LH side | - | - |
|
Remove in this Direction | - | - |
w/o Adaptive High Beam System:
1. Disengage the clamp and disconnect the 2 connectors.
w/o Adaptive High Beam System, for LH side:
1. Disengage the clamp.
w/ Adaptive High Beam System:
1. Disengage the claw to disconnect the connector.
Remove the 2 screws and bolt.
Remove the headlight assembly as shown in the illustration.