| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | SPIRAL CABLE SUB-ASSEMBLY | 84306 | - | - | - |
| 2 | WINDSHIELD WIPER SWITCH ASSEMBLY | 84650 | ( )
|
- | - |
| 3 | TURN SIGNAL SWITCH | 84329 | ( )
|
- | - |
| 4 | STEERING WHEEL SWITCH HOUSING | 84319 | ( )
|
- | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84306
1.REMOVE SPIRAL CABLE SUB-ASSEMBLY
84319
4.REMOVE STEERING WHEEL SWITCH HOUSING
|
Remove in this Direction | - | - |
Using pliers, expand the clamp as shown in the illustration.
While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.