| *A | for HV Model | - | - |
| ● | Non-reusable part | - | - |
| *1 | FRONT DISC BRAKE CYLINDER SLIDE BUSHING | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front brake removal/installation are shown below.
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC [C13CD00, C13CE00, C140000] may be stored. As there is no malfunction, clear the DTC. (for HV Model)
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected. (for HV Model)
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used. (for HV Model)
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION (for HV Model)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISABLE BRAKE CONTROL (for HV Model)
After waiting for 2 minutes with the ignition switch is off, perform the following procedure.
When the brake pedal is depressed or the door courtesy switch is turned on even if the power switch is off, the brake control system activates. Therefore do not depress the brake pedal or open/close the doors until the reservoir level switch connector is disconnected.
Disconnect the reservoir level switch connector.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
Check that the brake pedal cannot be further depressed.
3.REMOVE FRONT WHEEL
4.DRAIN BRAKE FLUID
|
|
47313A
5.DISCONNECT FRONT FLEXIBLE HOSE
47750
6.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
7.REMOVE FRONT DISC BRAKE PAD
9.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
|
|
47715A
10.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.
Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front disc brake cylinder slide pin (lower side).
Do not damage the front disc brake cylinder slide pin.
11.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
12.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
43512
13.REMOVE FRONT DISC
| *a | Matchmark | - | - |
Put matchmarks on the front disc and the front axle hub sub-assembly.
Remove the front disc.