| *1 | FRONT BRAKE PAD RADIAL SPRING | - | - |
| ● | Non-reusable part | - | - |
| *1 | FRONT DISC BRAKE CYLINDER SLIDE BUSHING | - | - |
| ● | Non-reusable part | - | - |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
|
|
47313A
3.DISCONNECT FRONT FLEXIBLE HOSE
47750
4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
5.REMOVE FRONT DISC BRAKE PAD
04945
6.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM
7.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
|
|
47715A
8.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.
Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front disc brake cylinder slide pin (lower side).
Do not damage the front disc brake cylinder slide pin.
9.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
10.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
43512
11.REMOVE FRONT DISC
| *a | Matchmark | - | - |
Put matchmarks on the front disc and the front axle hub sub-assembly.
Remove the front disc.