| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | REAR FLEXIBLE HOSE | 47319F | - | - | - |
| 8 | REAR DISC BRAKE CYLINDER ASSEMBLY | 47850 | - | - | - |
| 9 | REAR DISC BRAKE PAD | 04466 | - | - | - |
| 10 | REAR DISC BRAKE ANTI-SQUEAL SHIM | 04946 | ( )
|
- | - |
| ● | Non-reusable part | - | - |
| *1 | NO. 1 REAR DISC BRAKE CYLINDER SLIDE BUSH | - | - |
| ● | Non-reusable part | - | - |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Make sure to read the precautions of the electric parking brake system before removing the rear brake assembly.
for HV Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>PRECAUTION
for Gasoline Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model TMMF Made)>PRECAUTION
2.REMOVE REAR WHEEL
3.PERFORM REAR BRAKE PAD REPLACEMENT MODE
for HV Model:
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>TEST MODE PROCEDURE
for Gasoline Model:
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model TMMF Made)>TEST MODE PROCEDURE
4.DRAIN BRAKE FLUID
|
|
47319F
7.SEPARATE REAR FLEXIBLE HOSE
47850
8.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
04466
9.REMOVE REAR DISC BRAKE PAD
11.REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
|
|
12.REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
| *1 | Rear No. 1 Disc Brake Cylinder Slide Pin | *2 | Rear No. 2 Disc Brake Cylinder Slide Pin |
Remove the rear No. 1 disc brake cylinder slide pin and rear No. 2 disc brake cylinder slide pin from the rear disc brake cylinder mounting.
Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake cylinder slide bushing from the rear No. 2 disc brake cylinder slide pin.
Do not damage the rear No. 2 disc brake cylinder slide pin.
47775B
13.REMOVE NO. 1 BUSH DUST BOOT
47822
14.REMOVE REAR DISC BRAKE CYLINDER MOUNTING
42431
15.REMOVE REAR DISC
| *a | Matchmark | - | - |
Put matchmarks on the rear disc and rear axle hub and bearing assembly.
Remove the rear disc.