| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | DISABLE BRAKE CONTROL | - | - | - | ( )
|
| 3 | REAR WHEEL | - | - | - | - |
| 4 | BRAKE FLUID | - | - | ( )
|
- |
| 5 | REAR FLEXIBLE HOSE | 47319F | ( )
|
- | - |
| *A | for HV Model | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear brake flexible hose removal/installation are shown below.
If both left and right rear flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used. (for HV Model)
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION (for HV Model)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
|
|
47319F
5.REMOVE REAR FLEXIBLE HOSE
Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
Remove the bolt and separate the rear flexible hose from the rear axle beam assembly.
Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
Remove the clip and rear flexible hose.