| *1 | INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY | *2 | AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY |
| *3 | AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY | *4 | DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY |
Use the same procedure for LHD and RHD vehicles.
The following procedure is for LHD vehicles.
55480D
1.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
2.REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY WITH NO. 2 HEATER CONTROL SUB-ASSEMBLY
55902E
3.REMOVE NO. 2 HEATER CONTROL SUB-ASSEMBLY
55903A
4.REMOVE NO. 3 HEATER CONTROL SUB-ASSEMBLY
Disengage the claws to remove the No. 3 heater control sub-assembly.
Before removing the No. 3 heater control sub-assembly, make sure to set it to MAX COLD.
55901D
5.REMOVE NO. 1 HEATER CONTROL SUB-ASSEMBLY
Disengage the claws to remove the No. 1 heater control sub-assembly.
Before removing the No. 1 heater control sub-assembly, make sure to set the mode switch to FACE.