| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | NEGATIVE AUXILIARY BATTERY TERMINAL | - | - | - | - |
| 3 | NO. 1 RELAY BLOCK COVER | 82662A | - | - | - |
| 4 | SEMICONDUCTOR POWER INTEGRATION ECU | 82644 | - | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the semiconductor power integration ECU removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
82662A
3.REMOVE NO. 1 RELAY BLOCK COVER
82644
4.REMOVE SEMICONDUCTOR POWER INTEGRATION ECU
|
|
| *a | Lock Lever | - | - |
Disengage the claws to pull up the semiconductor power integration ECU.
Pull up the lock lever to disconnect the connector as shown in the illustration.
Disconnect the connector to remove the semiconductor power integration ECU.