Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for RHD) › from 2021.07
RM3700E _57 Power Source / Network _093026 NETWORKING _0483101 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E448355N03
5.667,2.167 5.917,2.167 false 3.208,1.333 3.542,1.333 false 0.76,1.333 1.094,1.333 false 0.604,1.198 0.885,1.552 0.281,0.354 18 false 1 5.479,2.042 5.667,2.333 0.188,0.292 18 false 2 3.01,1.25 3.385,1.49 0.375,0.24 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 POWER DISTRIBUTION BOX ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU - - - -
2 NETWORK GATEWAY ECU 89111 (Click here) - -

*1 ECU INTEGRATION BOX LH - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the central gateway ECU (network gateway ECU) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)
Central gateway ECU (network gateway ECU) Update ECU security key - (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system *1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE POWER DISTRIBUTION BOX ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU

Hide 89111 2.REMOVE NETWORK GATEWAY ECU

Z101186

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the claws more than necessary.




a.
E448356N01
2.292,0.104 2.573,0.458 0.281,0.354 18 false i

i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the network gateway ECU.