Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF RACK
RM3700E _59 Vehicle Exterior _093282 EXTERIOR PANELS / TRIM _0483104 ROOF RACK A

EXTERIOR PANELS / TRIM  ROOF RACK  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B590967N01
2.708,0.927 3.042,0.927 false 1.365,1.958 1.698,1.958 false 2.521,0.792 2.802,1.146 0.281,0.354 18 false 2 1.167,1.823 1.448,2.177 0.281,0.354 18 false 1 5.167,0.583 5.5,0.823 0.333,0.24 10 false x3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 ROOF HEADLINING ASSEMBLY - - - -
2 ROOF RACK ASSEMBLY 63470B (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the roof rack assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 63470B 2.REMOVE ROOF RACK ASSEMBLY

a.
B590969N01
0.5,0.135 0.781,0.49 0.281,0.354 18 false i 3.698,0.135 3.979,0.49 0.281,0.354 18 false ii 1.938,2.021 2.219,2.375 0.281,0.354 18 false iii

i.

Put protective tape around the roof rack assembly.


ii.

Remove the 3 nuts.


iii.

Disengage the rear roof rack retainer to remove the roof rack assembly.