The master cylinder pressure sensor is connected to the skid control ECU inside the brake actuator assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C054016 | Brake Pressure Sensor "A" Circuit Voltage Below Threshold | Divergence between brake pedal stroke sensor value of electric brake booster (brake booster with master cylinder assembly) and oil pressure value of skid control ECU (brake actuator assembly) is large. | Skid control ECU (brake actuator assembly) | Brake/EPB | A |
| C054017 | Brake Pressure Sensor "A" Circuit Voltage Above Threshold | Divergence between brake pedal stroke sensor value of electric brake booster (brake booster with master cylinder assembly) and oil pressure value of skid control ECU (brake actuator assembly) is large. | Skid control ECU (brake actuator assembly) | Brake/EPB | A |
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for RHD | A |
| for LHD | B |
A
B
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model TMMF Made RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT