The radio and display receiver assembly receives a reverse signal from the back-up light switch assembly.
The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.
The radio and display receiver assembly receives a reverse signal from the power distribution box assembly.
Move the shift lever to R and check if the back-up lights come on.
The back-up lights come on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
w/o Adaptive High Beam System: Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/o Adaptive High Beam System)>HOW TO PROCEED WITH TROUBLESHOOTING
w/ Adaptive High Beam System: Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Adaptive High Beam System)>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the H79 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H79)Location & Routingewd_type=routing;type=c;code=H79 Click Connector(H79)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assemblyewd_type=component;type=c;code=H79;pinno=28 |
||
| H79-28 (REV) - Body ground | Ignition switch ON
Shift lever in R |
11 to 14 V |
| H79-28 (REV) - Body ground | Ignition switch ON
Shift lever not in R |
Below 1 V |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Gasoline Model) | B |
| NG (for HV Model) | C |
A
B
C
Disconnect the H79 radio and display receiver assembly connector.
Disconnect the 4C power distribution box assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H79)Location & Routingewd_type=routing;type=c;code=H79 Click Connector(H79)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assemblyewd_type=component;type=c;code=H79;pinno=28 |
||
| H79-28 (REV) - 4C-2 | Always | Below 1 Ω |
| H79-28 (REV) or 4C-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
NG