Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › from 2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0443935 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B620237N01
6.385,0.323 6.719,0.323 false 6.396,0.708 6.729,0.708 false 5.302,2.396 5.302,2.719 false 6.208,0.563 6.49,0.917 0.281,0.354 18 false 1 6.219,0.156 6.5,0.51 0.281,0.354 18 false 2 5.344,2.719 5.625,3.073 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 HORN BUTTON ASSEMBLY 45130 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the horn button assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system*1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B473126

Be sure to read Precaution thoroughly before servicing.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 45130 3.REMOVE HORN BUTTON ASSEMBLY

Z101186

CAUTION:
B417753

·

When storing the horn button assembly, keep the airbag deployment side facing upward.


·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B620238C01
0.396,0.781 1.333,0.781 true 0.333,0.094 0.615,0.448 0.281,0.354 18 false i 4.604,0.094 4.885,0.448 0.281,0.354 18 false ii 0.198,0.677 0.479,1.031 0.281,0.354 10 false *a 1.865,1.792 2.115,2.021 0.25,0.229 12 true *B 3.052,1.781 3.302,2.01 0.25,0.229 12 false *A
*A w/ Entry and Start System *B w/o Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B592962C01
1.51,1.333 0.979,0.958 true 4.76,1.01 4.229,0.75 true 0.688,4.49 1.146,4.063 true 1.063,2.729 1.615,2.313 true 6.125,2.771 6.448,2.427 true 6.01,4.729 6.375,5.219 true 0.771,1.25 1.063,1.594 true 0.458,0.917 0.917,0.729 true 0.542,4.76 0.885,5.396 true 1.25,4.656 1.531,5.344 true 4.052,1.531 4.417,1.26 true 4.198,1.031 3.906,1.198 true 0.26,0.167 0.51,0.396 0.25,0.229 10 true *a 2.094,0.156 2.344,0.385 0.25,0.229 10 true *b 3.781,0.156 4.031,0.385 0.25,0.229 10 true *a 5.677,0.135 5.927,0.365 0.25,0.229 10 true *b 1.563,1.25 1.813,1.479 0.25,0.229 10 true *c 6.385,2.229 6.635,2.458 0.25,0.229 10 true *c 6.396,5.229 6.646,5.458 0.25,0.229 10 true *c 0.302,1.938 0.552,2.167 0.25,0.229 10 true *f 2.688,3.271 2.938,3.5 0.25,0.229 10 true *f 3.104,3.583 3.354,3.813 0.25,0.229 10 true *h 4.427,3.313 4.677,3.542 0.25,0.229 10 true *g 5.198,1.948 5.438,2.177 0.24,0.229 10 true *g 4.906,3.969 5.156,4.198 0.25,0.229 10 true *h 2.5,4.021 2.75,4.25 0.25,0.229 10 true *b 0.271,4.021 0.521,4.25 0.25,0.229 10 true *a 0.844,5.406 1.094,5.604 0.25,0.198 10 true *e 1.125,3.958 1.375,4.188 0.25,0.229 10 true *c 1.042,1.573 1.292,1.802 0.25,0.229 10 true *e 3.927,1.51 4.177,1.74 0.25,0.229 10 true *e 4.792,0.927 5.042,1.156 0.25,0.229 10 true *d 0.26,0.844 0.51,1.073 0.25,0.229 10 true *d 1.635,2.177 1.885,2.406 0.25,0.229 10 true *c 1.531,5.354 1.781,5.583 0.25,0.229 10 true *d 3.698,1.135 3.948,1.365 0.25,0.229 10 true *c 2.615,1.823 2.896,2.177 0.281,0.354 18 false i
*a Lock Position *b Unlock Position
*c Torsion Spring *d Pin
*e Protective Tape *f View A
*g View B *h View C


i.

Using a screwdriver, push in the torsion springs to disengage the pins as shown in the illustration.

NOTICE:

Do not drop the horn button assembly.




c.
B620239N01
4.344,2.156 4.479,2.469 0.135,0.313 18 true i 3.292,1.49 3.448,1.771 0.156,0.281 18 true ii 3.375,1.115 3.583,1.406 0.208,0.292 18 true iv 4.146,1.188 4.354,1.479 0.208,0.292 18 true iii

i.

Tilt the horn button assembly toward the seat and support it with one hand.

NOTICE:

When disconnecting the horn button assembly, do not pull the airbag wire harness.



ii.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



iii.

Using a screwdriver with its tip wrapped with protective tape, release the lock and remove the wire harness clamp.


iv.

Disconnect the horn connector.