Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMC Made) › from 2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0484411 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMC Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMC Made)  C124000  Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A"  


DESCRIPTION

The yaw rate sensor has a built-in acceleration sensor.

If the identification ID of the yaw rate sensor is different to that stored in the skid control ECU (brake booster with master cylinder assembly), this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C124000 Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A" The identification ID sent from the yaw rate sensor is different to that stored in the skid control ECU (brake booster with master cylinder assembly) for 1 second or more.
·

Incorrect yaw rate sensor (airbag sensor assembly) installed

·

Skid control ECU (brake booster with master cylinder assembly)


Brake/EPB A

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMC Made)>UTILITY

·

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration after clearing previously calibrated data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMC Made)>UTILITY



PROCEDURE

1.CHECK PART NUMBER (AIRBAG SENSOR ASSEMBLY)
a.

Check that the proper yaw rate and acceleration sensor (airbag sensor assembly) is installed.

OK:

Proper yaw rate and acceleration sensor (airbag sensor assembly) is installed.



Result:
Proceed to
OK
NG



OK

2.CLEAR DTC

NG

2.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435
Result:
Proceed to
NEXT



Post-procedure1

a.

Turn the ignition switch off.



NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
C124000 is output A
C124000 is not output B



A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

B