The rear side ultrasonic sensor (RRS sensor) is installed on the rear bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the rear side ultrasonic sensor (RRS sensor). If an open circuit or other malfunction occurs in the rear side ultrasonic sensor (RRS sensor), the rear side ultrasonic sensor (RRS sensor) does not operate correctly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1AF296 | Ultrasonic Sensor (Rear Right Side) Component Internal Failure | Rear side ultrasonic sensor (RRS sensor) malfunction | ·
Rear side ultrasonic sensor (RRS sensor) ·
Clearance warning ECU assembly |
Clearance Warning | B |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1AF287 and C1AF296 are output | B |
| C1AF296 is output | C |
| None of the above conditions are met | D |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
Replace the rear side ultrasonic sensor (RRS sensor) with a known good one.
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1AF296 is output | B |
| None of the above conditions are met | C |
A
B
C