Refer to DTC C051212.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C051262 | Right Rear Wheel Speed Sensor Signal Compare Failure | Any of the following is detected:
·
A lowest wheel speed is 10 km/h (6 mph) or more, the difference between the highest and lowest wheel speeds is 2 km/h (1 mph) or less, and the rotation direction of any one of the wheels is not detected for 15 seconds or more. ·
A vehicle speed is 30 km/h (19 mph) or more and the rotation direction of one of the wheels is different from those of other 3 wheels as well as it is not detected for 1 second or more. |
·
Rear speed sensor RH*1 ·
Rear speed sensor RH (rear axle hub and bearing assembly RH)*2 |
Brake/EPB | A |
*1: for AWD
*2: for 2WD
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Check the DTCs that are output.
| Result | Proceed to |
|---|---|
| Only C051262 is output | A |
| None of the above conditions are met | B |
A
B
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for AWD | A |
| for 2WD | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT