The headlight ECU sub-assembly LH determines the vehicle height and performs automatic headlight beam level control based on signals from the rear height control sensor sub-assembly LH via direct line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B241A1C | Rear Height Sensor Circuit Voltage Out of Range | Detection condition:
The ignition switch is ON. Malfunction status:
Abnormal vehicle height continuously detected Malfunction duration:
10 seconds or more |
·
Rear height control sensor sub-assembly LH ·
Harness or connector ·
Headlight ECU sub-assembly LH |
Headlight Control | A |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Adaptive High Beam System)>INITIALIZATION
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Adaptive High Beam System)>INITIALIZATION
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Turn ignition switch to ON.
Wait 10 seconds or more.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B241A1C is not output | A |
| B241A1C is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
OK
NG
Pre-procedure1
Disconnect the A110 headlight ECU sub-assembly LH connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(O116,A110)Location & Routingewd_type=routing;type=c,c;code=O116,A110 Click Connector(O116)Body>Floor Wire>Rear Height Control Sensor Sub-Assembly LHewd_type=component;type=c;code=O116;pinno=3,2,1 Click Connector(A110)Engine Compartment>Engine Room Main Wire>Headlight ECU Sub-Assembly LHewd_type=component;type=c;code=A110;pinno=16,17,15 |
||
| O116-3 (SHB) - A110-16 (SBR) | Always | Below 1 Ω |
| O116-2 (SHRR) - A110-17 (SHRL) | Always | Below 1 Ω |
| O116-1 (SHG) - A110-15 (SGR) | Always | Below 1 Ω |
| O116-3 (SHB) or A110-16 (SBR) - Body ground | Always | 10 kΩ or higher |
| O116-2 (SHRR) or A110-17 (SHRL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG