| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel injector assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.REMOVE INTAKE MANIFOLD
4.REMOVE EGR VALVE WITH EGR CCOLER ASSEMBLY
25624
5.REMOVE EGR VALVE ADAPTER
Using an 8 mm socket wrench, remove the bolt.
Disengage the guide to remove the EGR valve adapter.
23902
6.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly.
Click hereEngine / Hybrid System>M15A-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
23814B
7.REMOVE FUEL DELIVERY PIPE
|
|
23891
8.REMOVE FUEL DELIVERY SPACER
23291
9.REMOVE INJECTOR VIBRATION INSULATOR
82125N
10.REMOVE NO. 5 ENGINE WIRE
23250
11.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 3 fuel injector assemblies out of the fuel delivery pipe.
Remove the O-ring from each fuel injector assembly.
Attach a tag or label with the corresponding cylinder number to each fuel injector assembly so that they can be installed to their original locations.
Cover the fuel injector assemblies with plastic bags to prevent damage and contamination.