Home › Power Source / Network › M15A-FXE (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2021.07
RM3700E _57 Power Source / Network _092978 M15A-FXE BATTERY / CHARGING _0438219 BATTERY CURRENT SENSOR A

M15A-FXE BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A476154N01
6.521,0.281 6.802,0.281 false 1.167,1.167 1.448,1.167 false 2.656,2.583 2.938,2.583 false 2.083,2.917 2.365,2.917 false 3.25,3.417 2.917,3.417 false 6.333,0.146 6.615,0.5 0.281,0.354 18 false 1 1,1 1.281,1.354 0.281,0.354 18 false 2 2.469,2.396 2.75,2.75 0.281,0.354 18 false 3 1.917,2.75 2.198,3.104 0.281,0.354 18 false 3 3.333,3.281 3.635,3.583 0.302,0.302 18 false 3 2.635,1.313 2.917,1.667 0.281,0.354 10 false x2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 REAR UNDER SIDE COVER RH 76973F - - -
3 BATTERY STATE SENSOR ASSEMBLY 28850C - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 76973F 2.REMOVE REAR UNDER SIDE COVER RH

Hide 28850C 3.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A461925