Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › from 2021.07
RM3700E _58 Vehicle Interior _092990 SEAT _0446771 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B598476N01
6.479,0.292 6.813,0.292 false 6.448,0.615 6.781,0.615 false 4.802,2.031 5.135,2.031 false 4.677,0.583 5.01,0.583 false 5.26,2.969 5.594,2.969 false 5.979,3.448 6.313,3.448 false 0.792,3.677 1.125,3.677 false 1.438,4.156 1.771,4.156 false 2.031,2.24 2.344,2.438 0.313,0.198 10 false x4 6.292,0.135 6.573,0.49 0.281,0.354 18 false 1 6.25,0.448 6.531,0.802 0.281,0.354 18 false 2 0.615,3.531 0.896,3.885 0.281,0.354 18 false 4 5.083,0.458 5.365,0.813 0.281,0.354 18 false 3 1.24,4.01 1.521,4.365 0.281,0.354 18 false 5 5.656,2.833 5.938,3.188 0.281,0.354 18 false 6 6.375,3.333 6.656,3.688 0.281,0.354 18 false 7 5.469,1.906 5.75,2.26 0.281,0.354 18 false 8

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 FRONT SEAT HEADREST ASSEMBLY 71910A - - -
4 FRONT SEAT TRACK BRACKET OUTER COVER RH 72123A - - -
5 FRONT SEAT TRACK BRACKET INNER COVER RH 72127A - - -
6 SEAT TRACK BRACKET OUTER COVER RH 72137 - - -
7 SEAT TRACK BRACKET INNER COVER RH 72157A - - -
8 FRONT SEAT ASSEMBLY - (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

CAUTION:
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:

If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system*1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Power seat is available only on the driver side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B473126

Be sure to read Precaution thoroughly before servicing.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72123A 4.REMOVE FRONT SEAT TRACK BRACKET OUTER COVER RH

Hide 72127A 5.REMOVE FRONT SEAT TRACK BRACKET INNER COVER RH

Hide 72137 6.REMOVE SEAT TRACK BRACKET OUTER COVER RH

Hide 72157A 7.REMOVE SEAT TRACK BRACKET INNER COVER RH

Hide 8.REMOVE FRONT SEAT ASSEMBLY

a.
B598477N01
0.229,0.104 0.51,0.458 0.281,0.354 18 false i 4.365,2 4.646,2.323 0.281,0.323 18 false vii 1.406,3.979 2.156,4.281 0.75,0.302 18 false viii, ix 3.521,0.073 4.063,0.469 0.542,0.396 18 false ii, iii 0.208,1.938 1.094,2.271 0.885,0.333 18 true iv, v, vi

i.

Using a T50 "TORX" socket wrench, remove the 2 bolts on the rear side of the front seat assembly.


ii.

Operate the slide and vertical power seat switch knob to move the front seat assembly to the rearmost position.


iii.

Using a T50 "TORX" socket wrench, remove the 2 bolts on the front side of the front seat assembly.


iv.

Operate the reclining power seat switch knob to move the seatback to the upright position.


v.

Operate the slide and vertical power seat switch knob to move the front seat assembly to the center position.


vi.

Operate the slide and vertical power seat switch knob to move the front seat assembly to the uppermost position.


vii.

Disconnect the cable from the negative (-) auxiliary battery terminal.


CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



viii.

Disconnect the 2 connectors and disengage the clamps under the front seat assembly.


ix.

Disconnect the front seat airbag assembly connector under the front seat assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




b.
B583811N01
0.396,0 0.677,0.354 0.281,0.354 18 false i

i.

Remove the front seat assembly.

NOTICE:
·

2 or more people are required when carrying the front seat assembly out of the vehicle.

·

Protect the front seat leg.

·

Be careful not to damage the front seat assembly, body exterior or body interior.