Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › 1NZ-FE SFI SYSTEM
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248039 1NZ-FE SFI SYSTEM D

1NZ-FE ENGINE CONTROL  1NZ-FE SFI SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be displayed on the intelligent tester. The tester can display both current and pending DTCs.

·

Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.



CHECK FOR DTC (Using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.


e.

Press the YES button.



CLEAR DTC (Without using intelligent tester)


a.

Perform either of the following operations:

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI MAIN and ETCS fuses from the engine room relay block (located inside the engine compartment) for more than 1 minute.