1NZ-FE ENGINE CONTROL
1NZ-FE SFI SYSTEM
- PRECAUTION2011.08–2015.062015.06–2016.09from 2016.09
- PARTS LOCATION2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- SYSTEM DIAGRAM2011.08–2014.072014.07–2016.092016.09–2017.01from 2017.01
- HOW TO PROCEED WITH TROUBLESHOOTING2011.08–2014.072014.07–2015.06from 2015.06
- CHECK FOR INTERMITTENT PROBLEMS
- BASIC INSPECTION2011.08–2014.072014.07–2015.06from 2015.06
- REGISTRATION from 2015.06
- INITIALIZATION from 2016.09
- PROBLEM SYMPTOMS TABLE2011.08–2014.072014.07–2015.062015.06–2016.092016.09–2017.01from 2017.01
- TERMINALS OF ECM2011.08–2016.092016.09–2017.01from 2017.01
- DIAGNOSIS SYSTEM2011.08–2016.09from 2016.09
- DTC CHECK / CLEAR
- FREEZE FRAME DATA2011.08–2015.06from 2015.06
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART2011.08–2016.09from 2016.09
- DATA LIST / ACTIVE TEST2011.08–2015.062015.06–2016.09from 2016.09
- DIAGNOSTIC TROUBLE CODE CHART2011.08–2014.072014.07–2015.062015.06–2016.092016.09–2017.01from 2017.01
- P0010 Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic)2011.08–2016.09from 2016.09
- P0011, P00122011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0016 Deviation in the crankshaft position sensor signal and camshaft position sensor signal (2 trip detection...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0031, P0032, P101D from 2016.09
- P0031, P0032, P0037, P00382011.08–2014.072014.07–2016.09
- P0037, P0038, P102D from 2016.09
- P0100, P0102, P0103 2011.08–2016.09
- P0102, P0103 from 2016.09
- P0110, P0112, P0113 2011.08–2016.09
- P0112, P0113 from 2016.09
- P0115, P0117, P01182011.08–2016.09from 2016.09
- P0116 Either condition is met (2 trip detection logic): · When engine is started cold and warmed up, the engine...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0120, P0121, P0122, P0123, P0220, P0222, P0223, P21352011.08–2016.09from 2016.09
- P0130, P0132, P2195, P21962011.08–2014.072014.07–2015.062015.06–2016.09
- P0133 While idling with warm engine, response time for voltage output of heated oxygen sensor to change from rich...2011.08–2014.072014.07–2015.062015.06–2016.09
- P0134 Heated oxygen sensor (sensor 1) output does not indicate rich (more than 0.45 V) even once when conditions...2011.08–2014.072014.07–2015.062015.06–2016.09
- P0136 Following conditions (a) and (b) met for 6 minutes or more after engine warmed up (2 trip detection logic):...2011.08–2014.072014.07–2015.062015.06–2016.09
- P0136, P0137, P0138 from 2016.09
- P0171, P01722011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0300, P0301, P0302, P0303, P03042011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0327, P03282011.08–2016.09from 2016.09
- P0335, P03392011.08–2014.072014.07–2016.09from 2016.09
- P0340 When one of following conditions is met: · No camshaft position sensor signal to ECM while cranking (2 trip...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0351, P0352, P0353, P03542011.08–2016.09from 2016.09
- P0420 The oxygen storage capacity value is less than the standard value under active air fuel ratio control (1 trip...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0443 Both of the following conditions (a) and (b) are met (1 trip detection logic) (a) The target control value...2011.08–2015.062015.06–2016.09from 2016.09
- P0500 While vehicle is being driven, no vehicle speed sensor signal is sent to the ECM. (1 trip detection logic:...2011.08–2016.09from 2016.09
- P0504 Conditions (a) and (b) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON (b)...2011.08–2014.072014.07–2016.092016.09–2017.01from 2017.01
- P0560 Open in ECM back-up power source circuit (1 trip detection logic)2011.08–2016.09from 2016.09
- P0604 ECM RAM errors (Main CPU and sub CPU mirroring failure) (1 trip detection logic).
- P0606 Either condition is met (1 trip detection logic): · There is an ECM main CPU error. · There is an ECM sub CPU...
- P060A A CPU reset is performed after one of the following conditions is met (1 trip detection logic): · There is an...
- P060B There is an ECM main CPU communication error (1 trip detection logic). from 2016.09
- P060D Either condition is met (1 trip detection logic): · There is an ECM main CPU error. · There is an ECM sub CPU...
- P060E Either condition is met (1 trip detection logic): · There is an ECM main CPU error. · There is an ECM sub CPU...
- P0617 Conditions (a), (b) and (c) are met, and a positive (+B) battery voltage of 10.5 V or higher is applied to...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P0630 Either of the following conditions is met (1 trip detection logic): · The VIN is not stored in the ECM. · The... from 2015.06
- P0657 There is a throttle actuator power supply error (1 trip detection logic).
- P0724 Stop light switch assembly remains ON even when vehicle repeats 5 cycles of STOP (less than 3 km/h [1.86...2011.08–2014.072014.07–2016.092016.09–2017.01from 2017.01
- P1603, P16052011.08–2014.072014.07–2015.06
- P1603 After monitoring for startability problems (P1604) finishes and 2 seconds or more have elapsed after starting...2015.06–2016.09from 2016.09
- P1604 Either conditions is met (1 trip detection logic): · The engine speed is below 500 rpm with the STA signal on...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P1605 When idling with the accelerator pedal released and the vehicle stopped, this item detects when the...2015.06–2016.09from 2016.09
- P1607 ECM CPUs malfunction (1 trip detection logic)
- P2102, P21032011.08–2016.09from 2016.09
- P2109 The ISC learned value is approximately 3 times larger than normal even though the actual intake air amount...2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P2111, P21122011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P2118 Open in electronic throttle control system power source (+BM) circuit (1 trip detection logic)2011.08–2016.09from 2016.09
- P2119 Throttle valve opening angle continues to vary greatly from target opening angle (1 trip detection logic)2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- P2120, P2122, P2123, P2125, P2127, P2128, P21382011.08–2016.09from 2016.09
- P2121 Either of following conditions 1 or 2 met for 0.5 seconds (1 trip detection logic) 1. Difference between VPA...2011.08–2014.072014.07–2015.06from 2015.06
- P2195, P2196 from 2016.09
- P2237, P2238, P2239, P2252, P2253 from 2016.09
- P2610 ECM internal malfunction (2 trip detection logic) from 2016.09
- P2A00 The calculated value for the air-fuel ratio sensor response rate deterioration level is less than the... from 2016.09
- ECM Power Source Circuit2011.08–2014.072014.07–2016.09from 2016.09
- VC Output Circuit2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- Fuel Pump Control Circuit2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- Fuel Injector Circuit2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- Starter Signal Circuit2011.08–2014.072014.07–2015.062015.06–2016.09from 2016.09
- Brake Override System2011.08–2015.062015.06–2017.01from 2017.01
- MIL Circuit2011.08–2016.09from 2016.09
- Rough Idling2015.06–2016.09from 2016.09
- Engine Difficult to Start2015.06–2016.09from 2016.09
- Engine Stalls2015.06–2016.09from 2016.09
- Lack of Power2015.06–2016.09from 2016.09
IGNITION SYSTEM
CAMSHAFT OIL CONTROL VALVE
THROTTLE BODY
ECM
ACCELERATOR PEDAL
MASS AIR FLOW METER
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
IGNITION COIL AND SPARK PLUG
ENGINE COOLANT TEMPERATURE SENSOR
KNOCK SENSOR
AIR FUEL RATIO SENSOR
HEATED OXYGEN SENSOR
HEATED OXYGEN SENSOR(for Sensor 1)
HEATED OXYGEN SENSOR(for Sensor 2)
INTEGRATION RELAY