Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248041 CAMSHAFT OIL CONTROL VALVE G

1NZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A193057E02
0.067,0 0.365,0.273 0.299,0.273 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


Text in Illustration
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)

If the result is not as specified, replace the oil control valve assembly.


b.
A248873E04
0.063,0.115 0.302,0.333 0.24,0.219 10 false *a 0.594,0.927 0.833,1.146 0.24,0.219 10 false *b 0.583,1.969 0.802,2.135 0.219,0.167 10 false *c

Check the operation

i.

Connect the positive (+) lead from a battery to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If necessary, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.


Text in Illustration
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When applied
*c When cut off