Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248041 CAMSHAFT OIL CONTROL VALVE G

1NZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Start the engine and warm it up.


c.

Turn the intelligent tester on.


d.

Inspect the camshaft timing oil control valve.

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).


ii.

Check the engine speed when the camshaft timing oil control valve is operated using the intelligent tester with the engine coolant temperature at 50°C (122°F) or less.

HINT:
·

When performing the Active Test, the air conditioning should be on.

·

Engine coolant temperature when the engine is started should be 30°C (86°F) or less.



OK:
Control Range Specified Condition
OFF Normal engine speed
ON Rough idle or engine stalls (soon after camshaft timing oil control valve switched from OFF to ON)