Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248044 ACCELERATOR PEDAL A

1NZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)

a.
A115383

Disconnect the connector of the accelerator pedal sensor assembly.


b.

Remove the 2 bolts and the accelerator pedal sensor assembly.

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Do not disassemble the accelerator pedal.




Hide 78110K 2.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)

a.
A128266

Disconnect the connector of the accelerator pedal sensor assembly.


b.

Remove the 2 bolts and the accelerator pedal sensor assembly.

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Do not disassemble the accelerator pedal.