Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › MASS AIR FLOW METER › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248045 MASS AIR FLOW METER A

1NZ-FE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER

a.

Install a new O-ring to the mass air flow meter.

NOTICE:

Do not twist the O-ring.



b.

Install the mass air flow meter with the 2 screws.

Torque:
1.0 N*m (10 kgf*cm, 9 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the connector mass air flow meter.


d.

Engage the wire harness clamp.