Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248046 CAMSHAFT POSITION SENSOR G

1NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11101E 1.INSPECT CAMSHAFT POSITION SENSOR

A105341E15
1.568,1.256 1.724,1.437 0.156,0.181 10 2 1.759,1.256 1.915,1.437 0.156,0.181 10 1 0.037,0 0.223,0.157 0.187,0.157 10 *a

a.

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
Camshaft Position Sensor)

Standard Resistance:
Tester Connection Condition Resistance
1 - 2 Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω


HINT:

In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).


If the resistance is not as specified, replace the camshaft position sensor.