Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248047 CRANKSHAFT POSITION SENSOR G

1NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 15100Q 1.INSPECT CRANKSHAFT POSITION SENSOR

A064983E05
0.083,0.083 0.302,0.26 0.219,0.177 10 false *a

a.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 985 to 1600 Ω
Hot 1265 to 1890 Ω


HINT:

In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).


If the resistance is not as specified, replace the crankshaft position sensor.

Text in Illustration
*a Component without harness connected
(Crankshaft Position Sensor)