Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248049 ENGINE COOLANT TEMPERATURE SENSOR G

1NZ-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A369988E01
0.688,0.229 1,0.427 0.313,0.198 10 false *1 1.865,1.938 2.177,2.135 0.313,0.198 10 false *a 0.604,1.719 0.833,1.885 0.229,0.167 10 false 30 0.604,1.906 0.833,2.073 0.229,0.167 10 false 20 0.604,2.198 0.833,2.365 0.229,0.167 10 false 10 0.667,2.542 0.792,2.719 0.125,0.177 10 false 5 0.542,3.792 0.823,3.969 0.281,0.177 10 false 0.2 0.677,3.208 0.802,3.385 0.125,0.177 10 false 1 0.552,3.49 0.833,3.667 0.281,0.177 10 false 0.5 0.271,2.833 0.583,3.031 0.313,0.198 10 false kΩ 0.885,4.104 1.167,4.281 0.281,0.177 10 false -20 1.281,4.094 1.563,4.271 0.281,0.177 10 false 0 1.531,4.094 1.813,4.271 0.281,0.177 10 false 20 1.865,4.094 2.146,4.271 0.281,0.177 10 false 40 2.188,4.094 2.469,4.271 0.281,0.177 10 false 60 2.521,4.104 2.802,4.281 0.281,0.177 10 false 80 0.875,4.24 1.156,4.417 0.281,0.177 10 false (-4) 1.219,4.229 1.5,4.406 0.281,0.177 10 false (32) 1.5,4.24 1.781,4.417 0.281,0.177 10 false (68) 1.792,4.24 2.146,4.427 0.354,0.188 10 false (104) 2.115,4.229 2.469,4.417 0.354,0.188 10 false (140) 2.458,4.24 2.813,4.427 0.354,0.188 10 false (176) 2.875,4.219 3.396,4.417 0.521,0.198 10 false °C (°F)

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*1 Ohmmeter
*a Component without harness connected
(Engine Coolant Temperature Sensor)

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

In case of checking the engine coolant temperature sensor in water, do not allow water to contact the terminals. After checking, dry the engine coolant temperature sensor.


If the result is not as specified, replace the engine coolant temperature sensor.