Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 1) › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248051 HEATED OXYGEN SENSOR(for Sensor 1) G

1NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 1)  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR (for Sensor 1)

a.
A119369E51
0.178,0.148 0.343,0.313 0.165,0.165 10 *a 2.422,0.941 2.821,1.111 0.399,0.170 10 HT1A 0.782,0.941 1.007,1.185 0.225,0.244 10 +B 0.874,1.674 1.081,1.830 0.207,0.156 10 E2 1.538,1.193 1.04,1.027 false 1.945,1.187 2.386,1.027 false 1.538,1.508 1.137,1.737 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1A) - 2 (+B) 20°C (68°F) 5.3 to 7.5 Ω
1 (HT1A) - 4 (E2) Always 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Heated Oxygen Sensor)

If the result is not as specified, replace the heated oxygen sensor.