89465A
1.INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
Using SST, install the heated oxygen sensor.
| *a | Fulcrum Length 300 mm |
| *b | Fulcrum Length 30 mm |
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
This torque value is effective when SST is parallel to the torque wrench.
Pass the connector through the hole into the inside of the vehicle and install the oxygen sensor wire grommet.
Connect the heated oxygen sensor connector.
Install the wire harness to the wire harness bracket.
2.INSPECT FOR EXHAUST GAS LEAK
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY