Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 2) › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248052 HEATED OXYGEN SENSOR(for Sensor 2) G

1NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  INSPECTION  


PROCEDURE

Hide 89465A 1.INSPECT HEATED OXYGEN SENSOR

a.
A199834E07
1.531,1.271 0.969,1.083 false 1.896,1.25 2.448,1.063 false 1.531,1.625 0.938,1.802 false 2.521,0.969 2.958,1.208 0.438,0.24 10 false HT1B 0.708,0.927 1.031,1.135 0.323,0.208 10 false +B 0.698,1.719 0.979,1.958 0.281,0.24 10 false E2 0.135,0.104 0.333,0.333 0.198,0.229 10 false *a 1.802,1.208 1.917,1.375 0.115,0.167 10 false 1 1.542,1.208 1.656,1.375 0.115,0.167 10 false 2 1.802,1.5 1.917,1.667 0.115,0.167 10 false 3 1.531,1.5 1.646,1.667 0.115,0.167 10 false 4

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Heated Oxygen Sensor)

If the result is not as specified, replace the heated oxygen sensor.