Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM19S0E _51 Engine / Hybrid System _051450 1NZ-FE ENGINE MECHANICAL _0248072 FRONT CRANKSHAFT OIL SEAL A

1NZ-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51441C 2.REMOVE ENGINE UNDER COVER RH (for Plastic Type)

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Hide 12305 5.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

Hide 13407 6.REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY

Hide 15100C 7.REMOVE OIL PUMP SEAL

a.
A166924E05
1.74,0.677 2.208,1.146 true 1.583,0.573 1.76,0.729 0.177,0.156 10 false *1 0.531,1.625 0.75,1.792 0.219,0.167 10 false *a

Using a knife, cut off the oil seal lip.

Text in Illustration
*1 Protective Tape
*a Cut Position


b.

Using a screwdriver with its tip wrapped with protective tape, pry out the oil seal.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.