Home › Engine / Hybrid System › 2NZ-FE ENGINE MECHANICAL › DRIVE BELT
RM19S0E _51 Engine / Hybrid System _051451 2NZ-FE ENGINE MECHANICAL _0248084 DRIVE BELT A

2NZ-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.

Provisionally install the fan and generator V belt onto each pulley.

NOTICE:
·

Make sure that there is no foreign matter or liquid, such as oil, on the belt and pulleys.

·

Make sure that the V belt is securely fitted into the rib grooves of the pulley.




Hide 16361A 2.ADJUST FAN AND GENERATOR V BELT

a.
A116198E03
2.404,0.269 2.629,0.450 0.225,0.181 10 *2 0.342,1.008 0.560,1.189 0.218,0.181 10 *1

Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension.

Text in Illustration
*a OK
*b NG
V100135

Front of Vehicle

NOTICE:

Do not insert the adjusting bar between the camshaft timing oil control valve assembly and generator assembly. It could damage the camshaft timing oil control valve assembly.



b.
A116197E04
2.271,0.375 2.469,0.531 0.198,0.156 10 true A 1.948,1.906 2.146,2.083 0.198,0.177 10 true B

First tighten bolt A, then tighten bolt B.

Torque:
19 N*m (189 kgf*cm, 14 ft.*lbf)

for bolt A

54 N*m (551 kgf*cm, 40 ft.*lbf)

for bolt B



Hide 51441C 4.INSTALL ENGINE UNDER COVER RH (for Plastic Type)

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)