1.REMOVE FRONT WHEEL RH
51441C
2.REMOVE ENGINE UNDER COVER RH (for Plastic Type)
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)
16361A
4.REMOVE FAN AND GENERATOR V BELT
12305
5.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
13407
6.REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY
15100C
7.REMOVE OIL PUMP SEAL
Using a knife, cut off the oil seal lip.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver with its tip wrapped with protective tape, pry out the oil seal.
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.