Home › Engine / Hybrid System › 1NZ-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM19S0E _51 Engine / Hybrid System _051456 1NZ-FE INTAKE / EXHAUST _0248112 INTAKE MANIFOLD A

1NZ-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install the gasket to the intake manifold.


b.

Temporarily install the intake manifold onto the cylinder head sub-assembly with the 3 bolts and 2 nuts.


c.
A105631E17
1.583,0.229 1.771,0.427 0.188,0.198 10 true 1 0.917,0.052 1.073,0.229 0.156,0.177 10 true 2 2.24,0.042 2.385,0.219 0.146,0.177 10 true 3 0.063,1.115 0.167,1.26 0.104,0.146 10 true 4 3.083,1.135 3.25,1.344 0.167,0.208 10 true 5

Tighten the 3 bolts and 2 nuts in the order shown in the illustration.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


d.

Install the oil level dipstick.


e.

Engage the wire harness clamp and install the wire harness to the intake manifold.


f.

Install the 2 wire harness brackets with the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


Hide 44774 2.CONNECT UNION TO CONNECTOR TUBE HOSE

a.

Connect the union to connector tube hose to the intake manifold.


Hide 12261 3.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose to the intake manifold.


Hide 4.INSTALL STUD BOLT

a.

Using a "TORX" socket wrench E6, install the 3 stud bolts to the intake manifold.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 22030 5.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY