Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › THROTTLE BODY › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248042 THROTTLE BODY A

1NZ-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL THROTTLE BODY ASSEMBLY

a.

Install the new gasket from to the intake manifold.


b.

Install throttle body assembly with the bolt and 3 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Install wire harness bracket with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


d.

Connect the throttle body assembly connector.


e.

Engage the wire harness clamp and install the wire harness to the wire harness bracket.


f.

Connect the water by-pass hose to the throttle body assembly.


g.

Connect the No. 2 water by-pass hose to the throttle body assembly.


h.

Install the water filter bracket with the 2 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 17705 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

a.

Install the air cleaner cap sub-assembly with No. 1 air cleaner hose to the throttle body assembly with the 2 clamps.


b.

Tighten the hose clamp.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


c.

Engage the wire harness clamp and install the wire harness to the vacuum switching valve assembly.


d.

Connect the vacuum switching valve assembly connector.


e.

Connect the mass air flow meter connector.


f.

Engage the 2 clamps and connect the wire harness to the air cleaner cap sub-assembly and vacuum switching valve assembly.


g.

Connect the No. 2 fuel vapor feed hose to the intake manifold.


h.

Install the fuel vapor feed hose to the No. 1 air cleaner hose.


i.

Connect the fuel vapor feed hose assembly to the vacuum switching valve assembly and No. 1 air cleaner hose.


Hide 5.PERFORM INITIALIZATION

NOTICE:

Perform the following procedure after replacing the throttle with motor body assembly or any throttle with motor body assembly components. The following procedure should also be performed if the throttle with motor body assembly is cleaned.


a.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above step again.



b.

Connect the intelligent tester to the DLC3 and clear the DTCs (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>DTC CHECK / CLEAR).


c.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

Standard:
Transaxle Switch Condition Engine Idle Speed
Automatic Transaxle A/C switched off 650 to 750 rpm
Manual Transaxle 600 to 700 rpm


HINT:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in P or neutral.




d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Volt %. Fully depress the accelerator pedal and check that the value is 60% or more.


e.

Perform a road test and confirm that there are no abnormalities.