Home › Engine / Hybrid System › 2NZ-FE STARTING › IGNITION SWITCH
RM19S0E _51 Engine / Hybrid System _051463 2NZ-FE STARTING _0248151 IGNITION SWITCH A

2NZ-FE STARTING  IGNITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84450 1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY

NOTICE:
·

Perform the operation after situating the upper steering column bracket assembly in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.

·

Do not turn the upper steering column bracket assembly sideways or downward because doing so might release the upper steering column bracket assembly's component parts.



a.

Engage the 2 claws and install the ignition or starter switch assembly.


b.

Connect the connector.


Hide 45250 2.INSTALL STEERING COLUMN ASSEMBLY (for LHD)

Hide 45250 3.INSTALL STEERING COLUMN ASSEMBLY (for RHD)