When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control indicator light turns on.
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.
Using the intelligent tester, perform the Active Test (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light | OFF/ON | Vehicle is stopped and engine is idling |
Indicator light turns on/off.
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Using the intelligent tester, read the Data List (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| CCS Indicator M-CPU | Cruise control indicator (Main CPU) / OFF or ON | OFF: Cruise control indicator light off
ON: Cruise control indicator light on |
- |
The display is as specified in the normal condition column.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2NZ-FE) | B |
| NG (for 1NZ-FE) | C |
A
B
C