If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0503 | A malfunction in the vehicle speed signal is detected while cruise control is in operation. | ·
Anti-lock brake system*1 ·
Vehicle stability control system*2 ·
Vehicle speed sensor signal circuit ·
Vehicle speed sensor ·
Combination meter assembly ·
ECM |
*1: w/ ABS
*2: w/ VSC
Check for DTCs.
w/ VSC and Separate Type Yaw Rate Sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>DTC CHECK / CLEAR)
w/ VSC and Built-in Type Yaw Rate Sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>DTC CHECK / CLEAR)
DTCs are not output.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/ ABS) | B |
| DTC is output (w/ VSC and Separate Type Yaw Rate Sensor) | C |
| DTC is output (w/ VSC and Built-in Type Yaw Rate Sensor) | D |
A
B
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
C
D
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the cruise control main switch to -SET to activate cruise control.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P0503 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2NZ-FE) | B |
| NG (for 1NZ-FE) | C |
A
B
(See pageEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
C
(See pageEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)