Home › Drivetrain › U441E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM19S0E _52 Drivetrain _051466 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0248173 PARK / NEUTRAL POSITION SWITCH A

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch assembly to the automatic transaxle assembly.


b.

Temporarily install the 2 bolts.


c.

Replace the lock plate with a new one and install the nut, lock plate and washer.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.

Temporarily install the control shaft lever.


e.
C107759

Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.


f.

Remove the control shaft lever.


g.
C107760E07
0.708,0.583 1.417,0.896 true 0.698,1.292 1.479,1.188 true 0.5,0.469 0.688,0.677 0.188,0.208 10 true *a 0.49,1.198 0.677,1.406 0.188,0.208 10 false *b

Align the groove and the neutral basic line.

Text in Illustration
*a Neutral Basic Line
*b Groove


h.

Hold the switch in this position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


i.
C107761

Using a screwdriver, stake the nut with the lock plate.


j.

Install the control shaft lever with the nut and washer.

Torque:
12 N*m (125 kgf*cm, 9 ft.*lbf)


k.

Connect the connector to the park/neutral position switch assembly.


Hide 33820B 2.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C181847E04
1.583,0.229 0.656,0.813 true 1.594,0.74 1.021,0.938 true 1.583,1.229 0.656,1.01 true 1.625,0.125 1.813,0.313 0.188,0.188 10 false *a 1.635,0.646 1.823,0.823 0.188,0.177 10 false *1 1.656,1.135 1.875,1.333 0.219,0.198 10 false *2

Install the transmission control cable assembly to the control shaft lever with the nut.

Text in Illustration
*1 No. 1 Transmission Control Cable Bracket
*2 Clip
*a Marking

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

NOTICE:

Make sure that the marking on the cable is aligned with the slit in the No. 1 transmission control cable bracket before installing the cable.



Hide 51442C 6.INSTALL ENGINE UNDER COVER LH (for Plastic Type)

Hide 51405A 7.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)